Viatom Checkme Lite Manuel De L'utilisateur page 9

Palms facing up, place an electrode in the middle of right wrist;

For method C, place another electrode in the middle of left wrist;

For method D, place another electrode in the left lower abdomen;

5. The display will then show your ECG waveform.
The device will monitor your ECG continuously, however no data will be
saved until you press the
6. Press the
from left to right.
7. When the bar is fully filled, the device will analysis your data, and then show
the measurement result.
3.4 Oximeter
The Checkme Health Monitor measures the amount of oxygen in your blood (SpO2),
your pulse rate (PR) and pulse index (PI). The oxygen saturation (SpO2) is measured
and displayed as a percentage of full capacity.
Measuring without cable
To start a Oximeter measurement without cable,
1. If the device is power off, press the home button.
2. In the Main Screen, tap the "Pulse Oximeter" icon.
Insert the forefinger into the built-in SpO
3.
forefinger and do exert pressure.
4. When the device detects stable waveform, it will automatically start the
button.
button to start collecting your ECG data. The countdown bar moves
sensor as shown below. Relax your
2
8