Viatom Checkme Lite Manuel De L'utilisateur page 10

measurement. The countdown bar moves from left to right.
5. When the bar is fully filled, the device will analysis your data, and then show
the measurement result.
Measuring with Cable (Optional)
1. Connect the external SpO
2. Put your index finger or middle finger into the external SpO
sure the cable is positioned along the top of the hand, and the finger nail is
in the position as shown below.
3. If the device is power off, press the Home button. Tap the <Pulse Oximeter>
icon.
4. The display will then show your PLETH waveform, SpO
The device will monitor your ECG continuously, however no data will be saved
until you press the
5. Press the
from left to right.
6. When the bar is fully filled, the device will analysis your data, and then show
the measurement result.
sensor to the multi-functional connector.
2
button
button to start collecting your SpO
Finger nail position
and pulse rate.
2
data. The countdown bar moves
2
9
sensor. Make
2