Princess Grey Wolf Mode D'emploi page 15

• Keep the release button (17) pressed and
open the cover (18).
• If necessary, remove the dustbag (21).
Refer to the section "Mounting and removing
the dustbag".
• Remove the filter (33) from the filter holder
(34).
• Remove the dust from the filter using a soft
brush. If the filter is worn, use a new filter.
• Insert the filter (33) into the filter holder (34).
• If necessary, mount the dustbag (21).
Refer to the section "Mounting and removing
the dustbag".
• Close the cover (18) until the release button
(17) clicks into place.
332829 - Cleaning and replacing
the outlet filter (fig. K & L)
The outlet filter (37) reduces the amount of
dust entering the motor unit to a minimum.
The outlet filter (37) must be cleaned regularly.
The outlet filter (37) must be replaced after
several months or whenever worn or
damaged. Replacement outlet filters are
available from our service station.
Caution! Do not wash or rinse the outlet filter.
• Press the tab (35) and remove the cover
(36).
• Remove the filter (37) from the filter holder
(39).
• Remove the dust from the filter using a soft
brush. If the filter is worn, use a new filter.
• Insert the filter (37) into the filter holder (39).
• Mount the cover (36) until the tab (34)
clicks into place.
332830 - Cleaning and replacing
the HEPA filter (fig. K & L)
The appliance is equipped with a HEPA filter
(38). The HEPA filter is a special air filter which
removes more than 99% of the dust particles
that otherwise would recirculate back into the
air. The HEPA filter (38) must be cleaned
regularly. The HEPA filter (38) must be
replaced after several months or whenever
worn or damaged. Replacement HEPA filters
are available from our service station.
Caution! Do not wash or rinse the HEPA filter.
• Press the tab (35) and remove the cover
(36).
• Remove the filter (38) from the filter holder
(39).
• Carefully tap the plastic edge of the filter
(38) to remove the dust particles. If the
filter is worn, use a new filter.
Caution! Do not tap the filter itself to avoid
damage to the filter.
• Insert the filter (38) into the filter holder (39).
• Mount the cover (36) until the tab (34)
clicks into place.
Disclaimer
Subject to change; specifications can be
changed without further notice.
15