Sharp AQUOS AN-65AG1 Mode D'emploi page 22

Installing the wall-mount bracket (Continued)
Connect the power cord, antenna wire, and cables to the terminals on the back of the
4
Liquid Crystal Television.
For details, refer to the operation manual that came with the Liquid Crystal Television.
Use the cable holder on the back of the Liquid Crystal Television to bundle together the
5
cables.
This bundles together the
connected cables.
Remove the screw hole plugs (4 plugs) of
6
the wall-mount bracket on the back of the
TV and then screw in the 4 wall-mount
bracket unit screws (hexagonal socket
screws, M10 length: 30 mm) that are in-
cluded with the wall-mount bracket unit.
Carefully keep the removed screw
hole plugs.
Install the wall-mount bracket unit with the terminal cover removed.
If the terminal cover is attached, the wall-mount bracket unit cannot be installed.
E-8
Cable holders
Screw hole plugs (4 plugs)
Power cord
Included part
Allen wrench
Hexagonal socket screws
(M10 length: 30 mm)
Mark A
Included hexagonal socket screws (4 screws)
Use an Allen wrench to screw in the included
hexagonal socket screws into the Mark A holes.
Wall-mount bracket