Installing The Wall-Mount Bracket - Sharp AQUOS AN-65AG1 Mode D'emploi

Installing the wall-mount bracket

• Be sure to use at least two people to perform the wall-mount bracket installation work for the Liquid Crystal
Caution
Television.
• The installation work must be conducted while the Liquid Crystal Television is standing upright, so be
careful that it does not fall over.
Place the Liquid Crystal Television on a strong stand about 20 to 30 cm high and remove
1
the two back terminal covers.
Remove the 3 fastening screws from both the left and right stands on the back of the
2
Liquid Crystal Television.
Keep the removed screws (short × 2 screws, long × 4 screws).
(1) Remove the 2 screws from each of the stand edge covers (total of 4 screws from the
3
left and right sides).
Use the removed screws (total of 4 screws) as shown in Step 2 on page 10.
(2) Remove the stand fastening screws (2 screws each on
the left and right sides).
Edge covers
Edge cover screws
(For Model 65 inch Separate Type)
Remove the terminal covers while the Liquid
Crystal Television is standing upright.
(2 covers top and bottom)
Two terminal covers,
top and bottom
Removing the edge covers reveals
the stand fastening screws in the
center of the stands, so remove
these screws.
Long screws
Short screw
E-5