Initial Operation - Storch 592120 Mode D'emploi

GB
Thank you
for purchasing a STORCH product. You have purchased a quality product.
If you would like to suggest an improvement, or experience a problem with your product, please do not hesitate to
contact us.
Please contact your field sales representative or, in urgent cases, contact us directly.
Yours sincerely,
STORCH Service Department
Tel.:
Fax:
Free service hotline:
Toll-free order hotline:
Toll-free order fax:
Table of contents

1. Initial operation

2. If you take a break from work
3. Restarting work
4. Changing the foam can
5. Cleaning
Important note:
Always observe the foam manufacturer's instructions as printed on the can.
1. Initial operation
Hand-tighten the foam can on the adapter; makes sure that the can is vertical with the valve at the top to avoid spilling
foam when you screw the can on
Shake the foam can thoroughly before use (follow the manufacturer's instructions and make sure the gun is fitted)
Open the adjusting screw and start to use the foam to completely fill the gun with foam
The foam gun is now ready for operation
You can use the adjusting screw to adjust the foam feed
2. If you take a break from work
Leave the gun filled with foam and always leave a full can of foam on the gun; if the can is empty, proceed as descri-
bed in Step 4.
Close the adjusting screw
When storing, make sure that the can is vertical (gun pointing up)
+49 (0)2 02 . 49 20 - 112
+49 (0)2 02 . 49 20 - 244
0800 786 72 47
+49 800 7867244
+49 800 7867243
(only available in Germany)
10
Page
10
10
11
11
11