Lubrication; Optional Accessories - BTI PROFILINE TS 59E Manuel D'utilisation

2. Place the guide rail on a scrap piece of wood.
3. Set the plunge saw on 5 mm cut depth
4. Place the saw on the rear end of the guide rail.
5. Turn the saw on, press it down to the set cutting
depth and cut the splinterguard along the full
length in one contiuous operation. The edge of
the splinterguard now corresponds exactly to the
cutting edge of the blade.
WARNING: To reduce the risk of injury,
ALWAYS secure the guide rail (w) with a
clamp (x).
Speed adjustment (fi g. 1)
The speed can be regulated between 1750 and 4000/
min using the speed wheel (s). This enables you to
optimise the cutting speed to suit the material. Refer to
the following chart for type of material and speed range.
Type of Material to be Cut
Solid wood (hard, soft)
Chipboards and hard fi bre boards
Laminated wood, blockboards, veneered
and coated boards
Plastics, fi bre-reinforced plastics, paper
and fabric
Acrylic glass
Door cutting (fi g. 7)
1. Place the plunge saw with the outer guard (v) on a
clean, fl at fl oor.
2. Press the shoe (d) with the front side on the door
against the adjusted depth stop.
Dust extraction (fi g. 1)
Your tool is fi tted with a dust extraction outlet (i).
WARNING: ALWAYS connect the plunge saw
to a dust extractor!
WARNING: ALWAYS use a dust extraction
device designed in accordance with the
relevant regulations regarding dust emission.
MAINTENANCE
Your BTI power tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
WARNING: To reduce the risk of injury,
turn unit off and disconnect machine from
power source before installing and removing
accessories, before adjusting or changing
set-ups or when making repairs. Be sure
the trigger switch is in the OFF position. An
accidental start-up can cause injury.
WARNING: If the saw blade is worn replace it
with a new sharp blade.

Lubrication

Your power tool requires no additional lubrication.
Speed Range
5
Cleaning
2–5
WARNING: Blow dirt and dust out of the main
5
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
2–3
approved eye protection and approved dust
2–3
mask when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth
dampened only with water and mild soap.
Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.

Optional accessories

WARNING: Since accessories, other than
those offered by BTI, have not been tested
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only BTI, recommended
accessories should be used with this product.
BTI offers saw blades specially designed for your
plunge saw.
Consult your dealer for further information on the
appropriate accessories.
43
E N G L I S H