Hotpoint Ariston HB 07 EU Mode D'emploi page 16

en
speed each time shall not last longer than 30
seconds.
USING THE FOOD
PROCESSOR ATTACHMENT
To use the chopping bowl (only on some models):
1. First of all make sure the non-slip ring is
fixed to the bottom of the bowl.
2. Fit the knife blade on the pin in the bowl -
always fit the knife blade before adding the
ingredients.
3. Cut the food into small pieces and put them
into the bowl.
A small amount of water can facilitate
the smooth running of the appliance.
The mixture amount should not exceed
the max capacity of the bowl.
Max operation at high speed each time
shall not last longer than 30 seconds.
4. Align the two fasteners of the bowl lid with
the two clip positions of the bowl and push
down to lock them in place. Be sure to align
the arrow on the lid and the arrow on the
bowl.
The fasteners must be locked in the two
clip positions,
operating the bowl lid may rotate as the motor
rotates.
Make sure the food pusher is properly
fitted into its housing on the cover.
5. Assemble the motor unit into the bowl lid and
turn it clockwise to lock them.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
The speed adjusting dial cannot be used
with the TURBO button.
Never remove the lid until the blade has
come to a complete stop.
14
otherwise during
8. Remove the knife blade first before pouring
out the mixture.
The knife blade is very sharp: take care
when handling.
Max operation at high speed each time
shall not last longer than 30s.
Using the bowl and shredding/slic-
ing discs for processing (only on
some models) (E).
1. First of all make sure the non-slip base is
fixed to the bottom of the bowl.
2. Then insert the disc shaft into the pin on
the bottom of the bowl, select the desired
shredding/slicing disc (fine or coarse) and
assemble the shredding /slicing disc onto
the shaft with the appropriate side upwards
(one side is for shredding, the other side is
for slicing).
Extreme caution must be taken when
handling discs as they are very sharp.
Pull the two fasteners towards the outside to fit
the lid onto the bowl, making sure the lid arrow is
aligned with the bowl arrow.
The fasteners must be locked in the two
clip positions,
operating the bowl lid may rotate as the motor
rotates.
3. Insert the bottom part of the motor unit
into the opening on the bowl lid, and turn it
clockwise to lock.
4. Plug the appliance into the power outlet.
5. Put the food inside the feeding tube and
push it slowly with the food pusher. Do not
push heavily.
6. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
The speed adjusting dial cannot be used
with the TURBO button.
Never remove the lid until the cutting
disc has come to a complete stop.
otherwise during