Control Panel; Important - Michelin MPX 150 HL Mode D'emploi

USING
THE CLEANER

CONTROL PANEL

A - On/off switch
B - Detergent control tap (if
available).
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 5A).
2) Connect the water cleaner to the mains electricity supply by
plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. I
(fig. 7A).
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To operate the water cleaner with hot water, turn the ON/OFF
switch to the Hot Water position. (fig. 7A).
In water cleaners with the "Total Stop" system, the motor
!
starts and stops when the lever on the lance handle is actioned
or released.
! Do not block the handle lever in the delivery position.

IMPORTANT!

To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 8).
English
STOPPING THE CLEANER
1) Turn the burner off by rota-
ting the ON/OFF switch to the
"I" position (fig. 7A).
2) Let the cleaner run with
cold water only for at least
30 seconds to cool down the
boiler.
3) Stop the cleaner by turning
the selector switch to pos. "0"
(fig. 7A).
FIG. 7
4) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun.
5) Disconnect the water clea-
ner from the mains electricity
supply via the Solenoid switch
or by unplugging the plug from
the socket.
6) Turn off the water supply
tap (fig. 5A).
!
If the water cleaner is left,
even temporarily, turn it off by
using the Solenoid switch or
by unplugging the plug from
the socket.
!
Water cleaners with the
"Total Stop" device should
be considered as off when
the Solenoid switch is in the
"O" position or the plug is
unplugged from the socket.
!
When the water cleaner is
not used, close the safety de-
vice on the handle.(fig.10).
!
Dry use of the water
cleaner causes serious dam-
age to pump gaskets.
FIG. 8
- 19 -
USING THE MULTIREG
ADJUSTABLE NOZZLE
(fig. 9)
Pressure must be selected
with the gun switched off.
Low pressure washing and
detergent suction.
(Version with detergent
suction).
Shift the nozzle forward.
Washing at high pressure
with a concentrated jet of
water
Turn the nozzle in an anti-
clockwise direction.
Washing at high pressure
with a fan-shaped jet of
water
Turn the nozzle in a clockwise
direction.
FIG. 9
FIG.10