"Ce" Conformity Declaration - Michelin MPX 150 HL Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The most important instructions

are marked with the symbol:

INTRODUCTION

This manual must be read before installing, setting up and

using the cleaner. The manual is an integral part of the product.

It is composed of two parts, one of which is yellow.

Read the warnings and instructions in this manual carefully as

they provide important indications as to SAFETY IN USE and

MAINTENANCE, paying special attention to the general rules

for safety listed in the yellow booklet.

KEEP THIS MANUAL CAREFULLY FOR FUTURE CON-

SULTATION.

The contents of this booklet must be brought to the attention

of persons using this water cleaner.

CLASSIFICATION

The user must observe the conditions of use of the applian-

ce prescribed by the Rules, and particularly he must respect

the following classification:

As for the protection against electric shock, the H.P.cleaner

belongs to CLASS I.

The H.P. cleaner is factory set and all its safety devices are

sealed. It is forbidden to alter their adjustment values.

In the Hot water cleaner the water is heated by a burner feed

with Diesel fuel.

The H.P. cleaner must be always used on a firm and flat

ground, furthermore it must not be moved while it is working or

connected to the electric supply.

Failure to observe this prescription may cause danger for the

user.

The H.P. cleaner must not be used in the presence of corrosive

or potentially explosive atmospheres. (vapours or gas)

The appliance must be connected to a mains electricity supply

conforming to current legislation

sions of the IEC 60364-1

manufacturer's instructions.

A wrong electric connection may cause damage to persons,

animals or things, and the manufacturer cannot be considered

responsible for these.

(in compliance with the provi-

standard) and in accordance with the

English

The H.P. cleaners with power lower than 3 kW are equipped

with a plug for connection to the electric supply.

In this case please check if the electric power system and the

electric sockets are compatible with the max. power of the

appliance indicated on the plate. (kW).

In case of doubt, please apply to qualified personnel.

You are recommended to fit a differential solenoid switch with a

sensitivity of 30 mA upstream of the socket or in the mains.

If the socket and the plug of the machine are not compatible,

have the plug replaced with a suitable type by qualified per-

sonnel.

Before connecting the machine make sure that the data indica-

ted on the plate correspond to those of the electric supply.

Do not use extensions to feed the H.P. cleaner.

The electric safety of this machine may be assured only when it

is properly connected to an efficient grounding system in accor-

dance with the governing laws for electric safety. (In compliance

with the provisions of IEC 60364-1).

It is necessary to check this essential safety requisite. In case

of doubt, ask for accurate control of the power system by

qualified personnel.

The manufacturer may not be considered responsible for dama-

ges occurred because of the lack of the grounding system.

The appliance is disconnected from the electric supply only by

pulling out the plug or switching off the

Failure to respect the above absolves the manufacturer of all

liability and represents negligent use of the product.

The water cleaner is considered as a fixed device.

Water cleaners with the "Total Stop" device should be con-

sidered as off when the

or the plug is unplugged from the socket.