Michelin MPX 150 HL Mode D'emploi page 17

WAX-SOAP KIT
(If available)
Select the desired tank by
turning the selector appropri-
ately. Detergent can only be
delivered in the low-pressure
position. (Fig. 4).
COMMAND AND CONTROL DEVICES
! Before connecting the machine to the water supply and
to the power mains, it is essential to know the function of the
cleaner's command and control devices.
WATER CIRCUIT CONNEC-
TION
Connect the feed hose to
the mains (fig. 5A) and to
the hosetail on the cleaner
(fig. 5B).
Check that the pressure and
quantity of the water supplied
by the mains are sufficient for
the cleaner to work properly: 2
to 8 BAR (29 to 116 PSI).
Maximum temperature of fee-
ding water 50°C (122°F).
Connect the high pressure
hose to the cleaner (fig. 5C)
and to the lance (fig. 6).
IMPORTANT.
The cleaner must operate
with clean water. Dirty or
sandy water, corrosive che-
micals and solvents can
cause severe damage to
the cleaner.
Failure to respect the above
absolves the manufacturer
of all liability and repre-
sents negligent use of the
product.
English
FIG. 4
A A A A A A A A
B B B B B B B B
C C C C C C C C
FIG. 5
FIG. 6
Information
Respect the instructions provided by the water
utility company.
Current regulations specify that the appliance may not be con-
nected to the drinking water supply unless a suitable system
separator is fitted.
Use a suitable EN 12729 type BA system separator.
Water passing through a system separator is no longer classi-
fied as drinking water.
!
Warning
Do not connect the machine to a drinking water container.
ELECTRICAL CONNECTION
The water cleaner must be connected to a mains electricity
supply conforming to current legislation and standards.
Ensure that the mains voltage available is the same as the vol-
tage at which the cleaner is supposed to work; this is indicated
on the identification plate.
!
The electric cable must be protected from accidental cru-
shing.
Do not use the machine if the supply cable is damaged.
!
! The use of any electric appliance requires the respect of
some basic rules:
• Do not touch the appliance with wet or damp hands or feet.
• Do not use the appliance bare-footed or with unsuitable
clothing.
• Do not pull the supply cable or the appliance itself in order
to disconnect the plug from the electric supply.
(For water cleaners rated at less than 3 kW fitted with plug).
As for the protection against electric shock, the H.P.cleaner
belongs to CLASS I.
Failure to observe the above warning frees the manu-
!
facturer from all responsibility and constitutes negligent
use of the product.
- 17 -