Control Panel; Important - Michelin MPX 150 HP Mode D'emploi

turer from all responsibility
and constitutes negligent
use of the product.
USING
THE CLEANER

CONTROL PANEL

A - On/off switch
B - Temperature regulator
C - Detergent control tap (if
available).
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 5A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1
(fig. 7A).
!
Warning
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To use the cleaner with hot water, turn the temperature regu-
lator (fig. 7B) to the recommended washing values.
!
Warning
In water cleaners with the "Total Stop" system, the motor starts
and stops when the lever on the lance handle is actioned or
released.
!
Danger
Do not block the handle lever in the delivery position.

IMPORTANT!

To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 8).
English
USING THE ACCESSORIES.
C C
The high pressure washer has a nozzle with a flat angle jet for
cleaning large surfaces.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head with rotary
nozzle to clean the most stubborn dirt.
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
A A B B
Do not aim the jet at people, animals or electrical sockets.
FIG. 7
USING THE ADJUSTABLE HEAD (Fig. 9)
The adjustable head enables you to select a low or high pressu-
re jet. The pressure is selected by rotating the head.
High pressure pos. A.
Low pressure and detergent intake pos. B.
STOPPING THE CLEANER
1) Switch off the burner by turning the pressure regulator to
pos. "0" (fig. 7B).
2) Let the cleaner run with cold water only for at least 30 seconds
to cool down the boiler.
3) Stop the cleaner by turning the selector switch to pos. "0"
(fig. 7A).
4) Discharge the pressure from the H.P. hose by pressing the
trigger on the gun.
5)
aner from the mains electri-
city supply via the omnipolar
switch or by unplugging the
plug from the socket.
6) Turn off the water supply
tap (fig. 5A).
-If the water cleaner is left,
even temporarily, turn it off by
using the omnipolar switch or
by unplugging the plug from
the socket.
- Water cleaners with the
"Total Stop" device should
be considered as off when
the omnipolar switch is in
the "O" position or the plug
is unplugged from the sock-
et.
- When the water cleaner is not
used, close the safety device
on the handle.(fig.10)
- Dry use of the water cleaner
FIG. 8
- 23 -
!
Danger:
Disconnect the water cle-
!
Warning
   
FIG. 9
FIG.10