Guide Handle; Operation; A - Checks To Be Performed Before Use; B - Starting Up The Machine - Floorpul C150 U13 ERG Mode D'emploi

EN IT
5.1 GUIDE HANDLE (Fig.
1) Pad rotation lever release button (44)
Press the button (44) to release the pad
rotation start levers (42).
2) Pad rotation start levers (42)
Pulling the pad rotation levers (42) ena-
bles pad rotation.
When the levers (42) are released, pad
rotation stops and the machine stops au-
tomatically.
The levers (42) should be kept pulled to
achieve continuous machine operation.
3) Polishing liquid spray button (52)
When the button is pressed and held
down, the polishing liquid spray is acti-
vated; if the button is released, the spray
stops.
NOTE:
The spray works even when the pad is not ro-
tating.

6.1 OPERATION

6.1.a - Checks to be performed
before use
- If the electrical spray accessory is
mounted (optional), check that it contains
enough polishing liquid for the working
phase and that the nozzle is properly
connected and adjusted.
- Check the condition of the pad.
If worn, replace it.
- Check that the appliance, particularly the
mains cable, is not damaged in any way
that might compromise correct machine
operation or the operator's safety.
6.1.b - Starting the machine
21)
(Fig. 21)
WARNING:
Do not start the machine if it is tilted.
Do not start the machine if the pad is not
correctly mounted.
NOTE:
The machine will not start if the handle shaft
is upright.
DANGER:
Ensure your hands are dry before using the
appliance.
- Pull the lever up (43) and lower the han-
dle until it reaches the height desired.
- Press the button (44) to release the pad
rotation start levers (42).
- Pulling the levers (42) starts the ma-
chine.
- When both levers (42) are released, the
machine stops.
WARNING:
Never wrap the power cable around the
neck or body of the machine.

6.1.c - Pad pressure adjustment

(Fig. 22)
- Turn the handwheel (56) counter clock-
wise as far as possible (the pad is lifted
up).
- Start brush rotation, the green led lights
up.
- With your left hand keep the lever pressed
down and with your right hand, turn the
handwheel clockwise, until the red lied
lights up, then turn it counter clockwise
until the green led lights up.
- Correct operation is when the red and
green leds alternate.
EN - 6