Onboard Storage - Delta 36-6023 Manuel D'utilisation

J
ON-BOARD STORAGE
Storage is located on the left panel, right panel and back side of the tool as shown in Figures 22a & 22b.
b. Push Stick
N. Anti-kickback assembly (Stored behind Blade Guard Assembly)
a. Wrenches
M. Blade guard assembly
J. Fence
L. Miter gauge
c. Riving knife storage
NOTE: Prior to placing the rip fence in the storage position you must temporally remove the miter gauge from the storage position.
To store Fence (J), remove the fence from the machine. The storage orientation will require the fence to be flipped upside down and
re-attached under the left side of the machine. The mounting tabs on the table should fit into the slotted openings on the bottom of
the fence arms. Please see Figure(s) 23a and 23b for proper orientation.
ASSEMBLY
L
FIGURE 22a
FIGURE 23a
c
a
N
FIGURE 22b
FIGURE 23b
22
b
M