Delta 36-6023 Manuel D'utilisation page 17

Place blade (K) on the arbor shaft with the teeth on the blade pointing toward the front of the saw. Place flanged washer on the
shaft with the large side of the washer against the blade, then secure blade assembly with nut. See Figure. 13.
Tighten nut with blade wrenches (a). Open end wrench will fit on the arbor shaft between the inner flange washer and the motor
assembly (if necessary, turn arbor shaft to align flats on the arbor shaft to the wrench). Closed end wrench will fit on the nut. See
Figure 14.
Return wrenches (a) to onboard storage location. Position the riving knife in the "Thru-cut" position prior to installation of throat
plate.
Details for positioning the riving knife are on page 44 RIVING KNIFE POSITION AND ALIGNMENT Section. See Figure 15.
ASSEMBLY
TOOTH
DIRECTION
FRONT OF FRONT OF
SAW SAW
a
FIGURE 14
FIGURE 13
17
K
ARBOR ARBOR
SHAFT SHAFT