Tyco DSC WS4933 Instructions D'installation Et D'utilisation page 3

Figure 3: Mounting the Detector
Tamper Protection
The WS4933/WS4933EU/WS8933 includes a tamper resistant feature that prevents
removal from the mounting bracket without the use of a tool. To engage the tamper res-
istant feature, cut the small breakaway tab (marked E in Figure 3) located on the
mounting bracket and then install the detector. To remove the detector from the mount-
ing bracket once it has been made tamper resistant, insert an appropriate tool into the
tamper release opening located on the detector housing (marked B in Figure 1). Press
and hold while simultaneously turning the detector counterclockwise.
Owner's Instructions
Testing the CO Detector
NOTE: Performing a CO detector system test will generate an alarm trans-
mission. Notify the central station before testing.
Perform a CO detector system test by pressing the Test/Hush button for a minimum of
6 seconds. The red LED flashes and the sounder emits a temporal 4 pattern.
Perform a CO detector local test by pressing the Test/Hush button for a minimum of 2
seconds. The sounder will emit 2 short beeps.
Maintenance
Test the detector weekly to ensure proper operation. When low battery is indicated
(see Table 1 and Specifications) immediately replace the battery. Once a month, use a
vacuum cleaner to keep the air vents free of dust.
Audible and Visual Indications
The tri-colored LED (green, yellow, red) and a sounder on the detector provide local
visual and audible indication of the detector's status as listed in Table 1.
NOTE: The sounder and LED are not synchronized.
Table 1: Detector Status and Indication
Status
Normal
E
Alarm/Test
Detector
Trouble
Low Battery
Detector
End of Life
Power up
Tamper
LEDs
Green flash every 12
Off
seconds
Red flash every 12 ANSI S3.41 temporal 4 (press
seconds button to hush for 5 minutes)
Yellow flash every 6
One 100ms chirp every 45 seconds Fault
seconds
Yellow flash every One 100ms chirp every 45 seconds
12 seconds (press button to hush for 12 hours)
Yellow flash every
One 100ms chirp every 45 seconds Fault
23 seconds
Green, yellow, red
One 100ms chirp at end of power-
flash sequence every
up sequence
12 seconds
Green, yellow, red
flash sequence every Off
12 seconds
Radio
Sounder
Signalling
Normal
(none)
Alarm
Low
battery
None
Tamper