Anti-Tip Block; Parts Supplied - Fulgor Milano F7DMW24S2 Guide D'installation

22 1 ⁄ " (562 mm) mounting cleat
8
A
opening width
B 0" flush
9
C 1 ⁄ " (29 mm) front of cleat to cabinet face
64

Anti-Tip block

A
C L
Note: the mounting surface of the finished
Top view
Figure 6
A 22 1 ⁄ " (562 mm) mounting cleat opening width
8
B 24 1 ⁄ " (612.78 mm) flush opening width
8
1 ⁄ " (3.2 mm) from opening to top of shelf
8
C
No oven shown
Suggested electrical
outlet location
Front view
Figure 7

Parts Supplied

6 Screws
Flush Mount Deflector Vent (Stainless steel) Qty. 1
Mounting
cleat
Drawer
B
Cabinet
C
face
face
17
cleat must sit 1 / " (38.89 mm) back
32
from the face of the cabinet.
A
Anti-Tip block
B
C
Installation Guide
Install deflector as shown in Figure 8A and 8B.
Shelf detail showing the deflector vent during installation.
Position deflector vent and mark holes.
Pre drill using a 1 /16" (1.57 mm) bit before mounting.
Figure 8A
Shelf detail showing the deflector vent installed.
Figure 8B
Anti-Tip Block
Normal Installation Steps
Anti-Tip Block Installation Instructions
To reduce the risk of tipping of the drawer, the Anti-Tip block
must be properly installed located 14
mm) above the floor on which the Drawer Microwave will
sit. The 6" (152.4 mm) Anti-Tip block must be provided by
the installer. See Figure 1. The Anti-Tip block prevents serious
injury that might result from spilled hot liquids.
If the appliance is ever moved to a different location, the
Anti-Tip block must also be moved and installed. When
installed to the wall, make sure that the screws completely
penetrate the dry wall and are secured in wood or metal so
that the block is totally stable. When fastening, be sure that
the screws do not penetrate electrical wiring or plumbing.
Figure 9
EN
13 ⁄ -inches (376.2
16
5