Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
Installation Guide
EN
Special Warning
INSTALLATION AND SERVICE MUST BE PERFORMED BY
A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR
LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
Clearances and Dimensions
For SAFETY CONSIDERATIONS do not install drawer in
any combustible cabinetry, which is not in accordance
with the stated clearances and dimensions on pages 3 - 5.
See Figures 1 - 7.
Unpacking Your Drawer Microwave
• Remove all packing materials from inside the drawer.
DO NOT REMOVE THE WAVEGUIDE COVER, which is
located on the ceiling of the microwave cavity.
• Check the drawer for any damage, such as misaligned
or bent drawer, damaged drawer seals and sealing
surfaces, broken or loose drawer guides and dents inside
the cavity or on the front side of the drawer. If there is any
damage, do not operate the microwave and contact your
dealer or a FULGOR MILANO AUTHORIZED SERVICER.
Sealing
Surface
Waveguide
Cover
Important Notes to the Installer
• Read all of the Installation Manual before installing the
Drawer Microwave.
• Remove all packing material before connecting the
electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
2
Sealing
Surface
Oven
Cavity
Important Notes to the Consumer
Keep this manual with your Use & Care Manual for future
reference.
• As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use & Care Manual. Read all and
follow carefully.
• Be sure your Drawer Microwave is installed and
grounded properly by a qualified installer or service
technician.
Important Safety Instructions
WARNING If the information in this manual is not followed
exactly, a fire or electrical shock may result that could cause
property damage, personal injury or death.
WARNING To reduce the risk of tipping, the Drawer
Microwave must be secured by a properly installed Anti-
Tip block.
• This Drawer Microwave must be electrically grounded
in accordance with local codes.
• Make sure the wall coverings and the cabinets around
the Drawer Microwave can withstand the heat generated
by the appliance.
WARNING - Never leave children alone or unattended in
the area where a Drawer Microwave is in use. Never leave
the drawer open when the microwave is unattended.
WARNING - Stepping, leaning or sitting on the drawer
may result in serious injuries and can also cause damage
to the Drawer Microwave.
• Do not use the Drawer Microwave as a storage space.
This creates a potentially hazardous situation.
• Check that the time-of-day is in the display. If not,
touch STOP/CLEAR for safety reasons and to prevent
unintended use.
Clearances and Dimensions
• Dimensions that are shown in Figure 1 must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-hand
corner of the cutout. See Figure 10.
• Contact surface must be solid and level. Pay special
attention to the floor on which the Drawer Microwave
will sit. The floor of the opening should be constructed
of plywood strong enough to support the weight of
the oven (about 100 lbs/45 kg).
• Check location where the Drawer Microwave will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself
or under a gas or electric wall oven.
• Be sur e that the clearance of the floor between the
wall oven and the Drawer Microwave is a minimum of
2" (5 mm).
Publicité
Table des Matières
