Correct Measuring Posture; Wrapping The Cuff - Nissei DS-1873 Instructions

10 Press ON/OFF BUTTON and hour flashes.
The clock operates in 24-hour mode.
Adjust with M1 and M2 buttons.
11
Press ON/OFF BUTTON and minute flashes.
12
Adjust with M1 and M2 buttons.
13
Press ON/OFF BUTTON.
14
The clock is set and the unit is turned off.
The clock is displayed while the unit is turned off.

CORRECT MEASURING POSTURE

Sit at the table and let the table support your arm as you take the blood pressure measurement.
Make sure that the measurement location on the upper arm is at approximately the same height as the heart,
and that the forearm is extended naturally on the table and does not move.
You may lie on your back and take the measurement. Look at the ceiling, stay calm, and do not move your
neck or body during the measurement. Again, make sure that the measurement location on the arm is at
approximately the same height as the heart.

WRAPPING THE CUFF

1 With the tube of the cuff positioned in the direction of the fingertips, place it on your
left arm.
2 Wrap the cuff around the arm with the edge of the cuff approximately 2~3 cm above
the elbow.
3
Press the surface of the cuff to make sure that it is attached securely.
When wrapping the cuff, wrap it loosely enough around the arm so that two fingers can be placed between
the cuff and the arm. If the cuff is wrapped more tightly or loosely than this, inaccurate blood pressure
readings may result.
If you are wearing a shirt that might restrict circulation in your upper arm or you roll your sleeve up over
the upper arm, the blood flow will be restricted, preventing accurate measurement.
Refer to "PARTS NAMES AND PRODUCT COMPONENTS" on page 2 for circled numbers:
- 11 -
INSTALLING BATTERIES AND SETTING THE CLOCK
Output plug polarity : Center Minus
Output plug shape : External diameter
: Internal diameter
: Length
Remove the batteries when operating the
unit with AC adapter for extended period
of time.
When batteries are removed or AC adapter is
unplugged, the clock returns to the default
value. *Stored measurement results remain.
see fig.2
see fig.3
~
1 13
5.5ø±0.1 mm
2.1ø±0.1 mm
9.5±0.3 mm
page 4
page 4