Deleting Stored Data; Care And Maintenance - Nissei DS-1873 Instructions

The avarage of the stored result in the selected bank is displayed.
The latest result stored is displayed when there is only a single result and the clock display remains when there are no results stored.
The indication at the top of the display alternately changes from memory data number to date and to time.
The memory data is displayed for approximately 30 seconds. Approximately 30 seconds after MEMORY BUTTON is released, the
apparatus will turn off.
2 Press MEMORY BUTTON to move to next data.
The memory data number 1 is the latest among the stored data in the selected memory bank.
3 Every depression of the key switches among the memory data.
As MEMORY BUTTON is pressed, the memory data number increases; the bigger the number, the older the result.
4 Press ON/OFF BUTTON

DELETING STORED DATA

Deleting a single data
1
Show the data to be deleted following
the steps in MEMORY FUNCTIONS.
2
Press and hold down MEMORY BUTTON
M1 or M2
3
stored.
The displayed data starts flashing.
3
Hold down the button until the display
disappears.

CARE AND MAINTENANCE

Because the unit includes precision parts, care should be taken to avoid extreme temperature variations, humidity, shock, dust, and direct sunlight. Do not drop
or strike the unit. Make sure not to expose the unit to moisture. This unit is not water resistant.
Use only a soft, dry cloth to clean the unit. Do not use gasoline, paint thinner, or other strong solvents on the unit. Since the cuff may absorb perspiration and
other fluids, inspect it for stain and discoloration after each use. When cleaning the cuff, do not machine wash or scrub it. Use a synthetic detergent and gently
rub the surface. Make sure fluid never gets in AIR HOSE
When storing the unit, do not place heavy objects on it and do not coil AIR HOSE too tightly. When the unit has been stored at a temperature below the freezing
point, keep it for at least 1 hour in a warm place before using it. Remove the batteries if the instrument is to be stored for an extended period of time. Keep
Refer to "PARTS NAMES AND PRODUCT COMPONENTS" on page 2 for circled numbers:
and turn off the unit.
2
whichever the data is
4
. Air dry throughly.
10
Deleting all data in a bank
1
Press MEMORY BUTTON M1
and show the average of the bank to be
deleted.
2 Press and hold down selected MEMORY
BUTTON.
The displayed data starts flashing.
3
Hold down the button until the display
disappears.
- 13 -
~
1
MEMORY FUNCTIONS
page 7
see fig.6
or M2
3
GASOLINE
PAINT
THINNER
13
4