Infant Car Seat; Fold / Unfold - BABYTREND ST85 Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INfANT CAR SEAT

INfANT CAR SEAT ATTAChMEN
WARNING:
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
ONlY
approved SNAP TECh
TM
be used on the frame.
13) • Attach the car seat by facing the car
seat towards the stroller handle and
lining up the seat anchors on the side
of the car seat with the anchors on the
stroller frame and push them together
until they lock securely (Fig. 13).
TO REMOvE SEAT/INfANT
CAR SEAT
14) • To take off the seat or the infant car
seat, pull up on both the release levers
and pull seat or car seat upwards
(Fig. 14).
11
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Avoid
products can
TO fOld STROllER
WARNING:
must be taken when folding
and unfolding the stroller to
prevent finger entrapment.
CAuTION:
allow children near stroller
while folding.
15) • Pull the stroller backwards several
inches to adjust the front wheels to the
front.
Fig. 13
• Fold the stroller by pulling both release
triggers (Fig. 15a) and push handle
towards the floor. Make sure the front
wheels lie flat, then secure the stroller
in the folded position by locking the fold
latch, located on the right side of the
stroller, over the rivet (Fig. 15b).
TO uNfOld STROllER
CAuTION:
allow children near stroller
Fig. 14
while unfolding.
16) • Unlock the release lever (Fig. 16a) and
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 16b).
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

fOld / uNfOld

Care
do not
do not
Fig. 15a
Fig. 15b
Fig. 16a
Fig. 16b
12

Publicité

Table des Matières
loading

Table des Matières