Function And Operation - Menu System MS-I Série Mode D'emploi

7

FUNCTION AND OPERATION

7.1.1 CONTROLS
Appearance
7.1.2 DISPLAY
Display indicator
Function
Rotary switch
Function
Power stages
PushHold function
Temperature
Residual heat
Incorrect pan material
Error
SLIDECONTROL
SLIDECONTROL power
consumption
Description
To switch on the appliance, turn the rotary
switch out of the OFF position. The power stage
can be set using the rotary switch. Turning the
switch clockwise increases the power, whilst
turning it anticlockwise reduces the power.
*Additional rotary switch position only with
SLIDECONTROL hobs (turn clockwise until it
comes to a stop)
Description
Power stages 1 - 8 / P9 / P10
Hold current temperature value
The hold function only works if the pan is
positioned at the centre of a star.
If the temperature cannot be accepted
because the temperature rise is too rapid,
the HOLD display flashes.
Hold temperature set in °C
The hold function only works if the pan is
positioned at the centre of a star.
Illuminates when switched off with a pan
temperature of:
1 dash: >50°C
2 dashes: >75°C
3 dashes: >100°C
Message when an unsuitable pan material
such as aluminium is detected
An error is displayed with an "E" for error
and the error number, in this case no. 5
If the rotary knob is positioned at the
SLIDECONTROL position, the display first
shows the SLC and then the power [kW]
The power [kW] is only displayed in
SLIDECONTROL mode
19
MENU SYSTEM