Unold 28811 Notice D'utilisation page 31

26. Reinsert the coffee outlet into the support on the appliance.
cleaning the steam nozzle
27. Carefully detach the nozzle from the frother.
28. Carefully clean the nozzle with warm water and a mild
washing-up liquid. Rinse the nozzle with clear water and dry
it thoroughly.
29. Reattach the steam nozzle on the frother.
Detaching the brewer assembly
30. The automatic coffee machine has a detachable brewer
assembly, which is important for the coffee quality and the
operational reliability of the appliance. Clean the brewer
assembly regularly, if necessary daily.
31. Open the lateral cover. Always detach the coffee grounds
container first, then the brewer assembly, holding them on
the handle and pressing the plate with the label PRESS
downwards and extracting the brewer assembly.
32. If it is not possible to extract the brewer assembly, the water
drain pipe might be trapped. The water drain pipe is installed
in the upper left of the brewer assembly. Carefully pull on the
drain pipe until the brewer assembly can be detached. After
cleaning the gasket of the water drain pipe, grease it with a
silicone lubricant.
33. Rinse the brewer assembly with water. Do not clean the
brewer assembly in a dish-washer. To clean all components
of the brewer assembly, insert the brewer assembly key into
the round hole on the rear of the brewer assembly and turn it.
Rinse the brewer assembly with water.
34. Clean the perforated screens of the brewer assembly with
a soft brush, if necessary. The perforated screens can be
detached using the brewer assembly key.
35. Do not use cleaning agents or disinfectants to clean the brewer
assembly. Dry the brewer assembly with a soft cloth.
36. Grease the lateral guides as well as the red gasket of the
brewer assembly every once in a while with the silicone grease
enclosed. The red gasket should be replaced once a year or
according to its wear.
37. Also grease the water inlet port of the brewer assembly.
38. To better distribute the grease, actuate the brewer assembly
several times using the brewer assembly key. Reinsert the
brewer assembly into the automatic coffee machine.
39. Extract, empty and clean the coffee powder drawer beneath
the brewer assembly.
40. Clean the inside of the automatic coffee machine with a dry
cloth or a cleaning brush.
41. Then put the brewer assembly back to its initial position. The
brewer has two arrow marks on the front beneath the handle.
These must point at one another to allow the insertion of the
brewer assembly.
42. First reinsert the brewer assembly until it latches into place,
then reinsert the coffee grounds container.
43. Should the brewer assembly be trapped, thus making its
extraction or reinsertion impossible, the appliance has to be
inspected and repaired by our after-sales service
44. All components of the automatic coffee machine have to be
dry before reinserting them and using the appliance.
Never clean the brewer assembly with a cleaning agent or disinfec-
tant.
Never dry the brewer assembly or other components with a hair dryer
or other electric drying appliances or in the oven/microwave.
31