Table des Matières
Publicité
C. Fault code
The washer stops when the program is running. The display window shows fault
code "F24", fault codes from "F04' to "F07", "F13", "F23" or "UNB".
If fault code "F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code "F04" to "F07", "F23" shown
Electronic module fails.
Press "Power Supply" key for 3 sec to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door
(PTC) to check whether the door is closed.
adequate for the machine's 10 A Current Rating.
Open or close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
The electrical power cable must be replaced exclusively by a licensed electrician.
power supply and contact with after-sale service.
If fault code "UNB" is shown
Unbalance alarm.
Press "Power Supply" key for 3 sec to turn off the machine. Open the door and
re-tidy clothes and then rotate program knob to single dehydration mode. Spin
clothes to dry again.
If fault occurs again, disconnect power supply and contact with after-sale service.
17
18
Publicité
Table des Matières
