Parking Position; Cleaning The Dust Filter - Electrolux twinclean CYCLONIC Mode D'emploi

Masquer les pouces Voir aussi pour twinclean CYCLONIC:
Table des Matières

Publicité

19
22
25
12
1180066-21.indd 12
20
23
26
28
29
21
24
27
English

Parking position

19 When you pause during cleaning, the tube can be
attached to the rear of the vacuum cleaner.
20 When storing, the vacuum cleaner can be placed
on end and the tube attached at the bottom of the
vacuum cleaner.
How to use the telescopic tube
21 Extend or shorten the telescopic tube by pushing the
release button towards the nozzle and simultaneously
adjusting the length of the telescopic tube. There is
a catch at both ends of the telescopic tube. Certain
models only have one release button.
Emptying the dust container
Electrolux Twinclean's dust container must be emptied
when it is full to the Max sign. The dust container must
never be overfilled.
22 Press the release button at the rear of vacuum cleaner.
23 Lift the dust container out.
24 Empty it over a wastepaper basket by pressing the
release button. Put the dust container back and press
the rear part of the container until it clicks into place.

Cleaning the dust filter

Electrolux Twinclean has a dust filter that should be
cleaned now and then to secure a constant high suction.
When it is time to clean the filter, the filter light on the
vacuum cleaner will flash. The filter is cleaned while in the
vacuum cleaner.
25 Turn off the vacuum cleaner when the filter light
flashes.
26 Open the cover by lifting the release catch.
27 Lift up the filter holder and turn it a half turn so that
the filters change places with each other and put the
filters back into the vacuum cleaner.
28 Turn the left filter a full turn in the direction of the
arrow. The filter light begins to flash and the vacuum
cleaner starts, and as you turn, the filter is cleaned.
After you have made a full turn, the vacuum cleaner
turns off and the filter light stops flashing. You can
now close the cover.
About once each year, when the filter light begins to flash
more frequently, the filters need to be washed.
A
Lift out the filters according to the above.
B
Remove one filter at a time from the filter container
(29) by pressing the marked release button and
turning the filter.
C
Rinse the filters in lukewarm water and let them dry.
D
Thread the filters back into the filter holder.
2/4/08 4:47:37 PM

Publicité

Table des Matières
loading

Table des Matières