Foppapedretti chic Notice D'utilisation page 12

GB
ASSEMBLY
Important note: the images and instructions contained in this handbook refer to one version of the
stroller; some components and functions described herein may vary according to the version of the
stroller you have purchased.
UNFOLD THE STROLLER (fig.1, fig.2)
Press the folding lock button and then lift up the handlebar to open the folding lock.
Step on the lever, and then lift up the handlebar until the stroller is unfolded.
Make sure the pushchair has been opened correctly.
INSTALL REAR WHEELS (fig.3, fig.4, fig.5, fig.6, fig.7)
Insert the rear wheel group into the end of the tubes of the rear legs.
Il supporto ruote è correttamente assemblato quando i pin metallici si bloccheranno nei fori presenti
sui tubi della struttura.
Assemble the rear wheels along the arrow direction..
Press the button situated on the center of wheel and pull it to take the wheel apart from the axle.
INSTALL FRONT WHEELS (fig.8. fig.9, fig.10)
Insert the end bushing into the slot situated in the center of the wheel block.
Press the button down front wheel blocked. Sollevare il pulsante verso l'alto per attivare il movimento
piroettante.
Press the steel button front wheel released.
PARKING BRAKE (fig.11)
To apply the brake: Press the brake lever, push the pushchair forward gently to ensure the brake has
been applied correctly.
To release the brake: Lift the brake lever as shown.
ADJUSTING THE HANDLEBAR (fig.12)
Press both buttons "A" side handle and rotate the handle to the desired position.
FITTING THE BUMPER BAR (fig.13, fig.14, fig.15, fig.16, fig.17)
Assembly: Align the bumper bar and insert it in its seat on both sides, a click will indicate the correct
assembly.
Disassembly: Push the release button "A" on each side of the bumper bar and contemporary lift the
bar upwards to hook it off.
Unhook the bumper bar on only one side : Push the release button "A" on one side of the bumper
bar and contemporary lift the bar upwards to open it as a gate.
Push the buttons "A" on both sides, to adjust the height of the bumper bar.
ADJUST THE FOOTREST (fig.18)
Press buttons "A" and adjust the footrest in the required position.
CHIC 12