Inserting Threaded Cable Connection For Straight Screw Connection - Interroll DM Série Instructions De Montage

22
Interroll Drum motor DM series connecting cable
Installing the connecting cable

Inserting threaded cable connection for straight screw connection

Shell nipple and thrust screw
1 Shell nipple
4 Screw the shell nipple (1) of the screw connection into the shaft end and tighten it with the
14-mm open-end wrench.
4 Screw the thrust screw (2) of the screw connections tightly onto the thread of the shell nipple
using a 20-mm open-end wrench.
4 Route the connecting cable properly and place it in the switch cabinet.
4 For the remaining installation of the drum motor, observe the notices in the Interroll drum
motor DM series operating manual.
2
1
2 Thrust screw
Translation of original instruction manual
Version 2.0 (06/2018) en