Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Make sure that the cutting discs rotate in the
correct direction.
• Do not use the machine with the cutting discs
facing upwards or to the side.
• Only use cutting discs that are suitable for use
with the machine.
• Only use cutting discs with the correct dimensi-
ons.
• Do not use other accessories than cutting discs.
• Do not use the machine when a maximum slot
depth is required that exceeds the maximum
slot depth of the cutting discs.
• Make sure that your hands do not touch the
rotating parts.
• Always work in the correct working direction
(see indication on the base).
• Let the machine run at no load in a safe area
after mounting the cutting discs. If the machine
vibrates strongly, immediately switch off the
machine, remove the mains plug from the
mains, and try to solve the problem.
• Beware that the cutting discs continue to rotate
for a short period after switching off the machi-
ne. Do not attempt to bring the cutting discs to
a standstill yourself.
• Never put the machine down on a table or a
workbench before it has been switched off.
Kickback
Kickback is the upward and backward movement of
the cutting discs when the cutting discs unexpec-
tedly touch an object. Securely hold the machine
with both hands during use. Keep your attention
focused on the operation.
Kickback is usually caused by:
-
unintentionally touching hard objects or materi-
als with the rotating cutting discs;
-
blunt cutting discs;
-
cutting discs that are not properly mounted;
-
cutting into a previous cut;
-
a lack of attention to the operation;
-
an instable stance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
WWW.VONROC.COM
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
2. MACHINE INFORMATION
Intended use
Your wall chaser has been designed for making
slots in masonry. The machine is only suitable for
right-hand use.
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Slot width
Slot depth
Cutting disc
Diameter:
Bore:
Spindle thread
Protection class
Weight
Sound pressure L
PA
Acoustic power L
WA
Uncertainty (K)
Vibration (main grip)
Vibration (auxiliary grip)
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
EN
. If you use an
2
WC501AC
230V~
50Hz
1700W
4000 min
-1
14/19/29mm
5-40mm
150mm
22.2mm
M12
IP20
5.1kg
85.3 dB(A)
96.3 dB(A)
3 dB(A)
7.214 m/s
2
5.843 m/s
2
1.5 m/s
2
7
Publicité
Table des Matières
