Operation; Use As Hand-Guided Device; Trouble-Shooting; Maintenance And Care - APA 27100 Manuel De L'opérateur

6.4 OPERATION

Only operate the fan heater when driving or when the motor is running, otherwise there is a risk that the battery
of your vehicle may be discharged.
Using the switch (Position 6 in the overview), you can choose between two modes:
If you set the switch to „Heat", the fan heater acts as a heater, in the „Fan" setting, the fan is operated without switching the
heating element on. You can switch the device off by bringing the switch to the „0" position.

6.4.1 USE AS HAND-GUIDED DEVICE

In this mode, the device may not be used when the vehicle is in motion.
Carefully separate the housing from the fixture pedestal. Fold the handle out
(Position 5 in the overview). Hold the device with one hand, and use the other to
pull the handle out of the device by the metal ring, see Figure 5. Plug the connector
into the 12 V vehicle socket. Switch the device on using the switch. Now you can
target individual areas to warm or cool them. Pay attention to ensure sufficient safety
distance to surfaces. After completing your task, switch the device, bring the switch
to the „0" position, and pull the connector out of the socket.

7. TROUBLE-SHOOTING

Problem Possible cause
The connector has not been inserted correctly
into the vehicle socket.
The fan heater
With some vehicles, power is only supplied to the
is not working
vehicle socket when the motor is running.
The fuse of the vehicle socket has blown.

8. MAINTENANCE AND CARE

8.1 MAINTENANCE

The fan heater is maintenance-free if used according to its intended purpose.

8.2 CARE

Before cleaning, switch the fan heater off and remove the plug from the socket. Clean the housing of the device with a soft, dry
cloth. Do not use any aggressive cleaning agents or solvent-based cleaners. Never allow liquids to ingress into the housing. The
inlet and outlet openings may be cleaned with a paintbrush, a small brush or carefully with a vacuum cleaner.

9. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected
separately and disposed of in an environmentally responsible manner for recycling. Please contact your
community or city administration regarding disposal options for electrical and electronic scrap.

10. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
8
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 5: Unfold the handle
The solution
Pull the connector out of the socket and insert again.
Start the motor.
Replace the fuse belonging to the vehicle socket.
info@eal-vertrieb.com
www.eal-vertrieb.com