Canopy Assembly - NOMA Scandinavian 052-9335-6 Manuel D'utilisation

2.2 Canopy Assembly

Remove three of the six screws and lock washers
(every other one) securing the motor collar to the
top of the fan motor housing (fig. 10).
Guide all the wires through the base of the canopy
(fig. 10).
Attach the canopy directly to the motor top and
tighten with the three sets of coupling screws with
split washers (fig. 10).
2.3 Hanging Fan Assembly to Mounting Bracket
Raise the canopy-motor assembly to the mounting
bracket's hook and hang by the hole on the canopy.
This allows for hands-free wiring (fig. 11).
mounting bracket's hook, follow the wiring instructions
(step 4).
3. Drop-mount Installation
3.1 Dismantling Downrod Assembly
Remove the clip and peaked pin from the
downrod (fig. 12).
Remove the ball screw from the nylon ball
and save for future use (fig. 12).
Slide the ball down, without removing it.
The pin is now exposed. Remove the pin
and save for future use (fig. 12).
3.2 Securing Nylon Ball
Place the canopy on top of the motor housing.
Carefully thread the silver cord and all the wires through the downrod assembly.
Insert the pin into the downrod.
Slide the ball up until the pin fits firmly into the ball. Insert the ball screw into the
ball and tighten properly (fig. 13).
Mounting
bracket
Nylon
ball
Downrod
Peaked
pin
Clip
Screw
Canopy
Motor collar
Canopy