NOMA Scandinavian 052-9335-6 Manuel D'utilisation page 8

Toll-free: 1-866-827-4985 · model nos. 052-9335-6
1. Installing Mounting Bracket
Remove the four sets of side screws from mounting
bracket and save for future use (fig. 6).
Attach the mounting bracket to the normal masonry
ceiling or wooden ceiling as indicated below.
Normal masonry ceiling
Securely attach the mounting bracket to
an outlet box marked "Acceptable for Fan
Support", using the supplied outlet box
screws with lock washers (fig. 7).
Mounting
bracket
WARNING! The mounting bracket must sit firmly against the outlet box. If the
outlet box is recessed, remove the wall board until the mounting bracket comes
into contact with the box. If bracket and/or outlet box are not securely attached,
the fan could wobble or fall.
CAUTION!
Before drilling, ensure there are no electrical wires or water pipes behind the
drill spots.
While drilling, we recommend wearing protective goggles and hearing
protection.
2. Flush-mount Installation (skip step 3)
2.1 Blade Assembly
Attach the blade decoration and blade
bracket to the blade (fig. 9).
Apply the blade screws and secure properly
(fig. 9).
Note: This fan includes four dual-finished
blades. Depending on personal
preference, choose the side that best
suits the décor or furniture of your
room.
Drill two mounting holes in the ceiling joist.
Securely attach the mounting bracket to
the ceiling, using the two sets of long
wood screws with flat washers (fig. 8).
Mounting
bracket
Lock washer
Wooden ceiling
Flat washer
Blade screw
Blade arm
Blade
Blade decoration