Environmental Protection - NOMA Scandinavian 052-9335-6 Manuel D'utilisation

Problem Possible reason
Wires are not properly connected.
Light bulb is faulty.
Light does
This fan is equipped with a 70 W
not work
LIMITER that will automatically turn
exceeds the maximum wattage level.
Remote is not working.
Fan is in reverse mode (blades are
moving in a clockwise direction).
Fan does
not seem to
provide the
expected
Fan is not properly located.
Screws securing blades to motor are
losse.
Screws securing blade assembly are
loose.
Canopy and mounting bracket are
not tightened securely.
Fan
Blades are unbalanced.
wobbles
or shakes
excessively
Remote
Non-match coding between remote and
does not
receiver.
work

ENVIRONMENTAL PROTECTION

Used electrical appliances are recyclable and should not be discarded in your regular
domestic waste. Please actively support us in conserving resources and protecting the
environment by returning this appliance to a collection centre (if available).
Battery must be recycled or disposed of properly. Dispose of as per the requirements
of your local municipality.
Solution
Ensure wire connector in the switch
housing is connected.
Remove light bulb and replace with a
new one of the same type.
with lower wattage bulbs so that the
total wattage will be below 70 W.
Check and ensure the remote works.
Counter-clockwise (forward) direction is
recommended in warm weather. Switch
to stop. Use the eraser end of a pencil to
set the forward/reverse switch to the left
side.
Adjust the fan so that the ends of the
blades have at least 12" (30 cm) clearance
from walls or other obstructions, in the
centre of the room.
Tighten the screws.
Tighten the screws.
Tighten the mounting bracket to the
outlet box.
Check by selecting a point on the ceiling
above the tip of one of the blades.
Measure this distance and ensure all
blades are same (fig. 31). If all blade
levels are not equal, adjust accordingly.
If fan woddle persists, apply the balancing
kit (see page 15).
Within 30 seconds after power supply is
switched on again, press and hold buttons
1 and 3 simultaneously for five seconds.
The red LED indicator flashers.
Now the remote and receiver are paired.
The fan runs at low speed and with the
fuse or circuit breaker box. Wait for at
least 10 seconds and switch on the power
supply again.