Safety Instructions; Electrical Connection - Electrolux EDP2074PEW Notice D'utilisation

should be washed in hot water with an extra amount of
detergent before being dried in the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, rubber backed articles and clothes
or pillows fitted with foam rubber pads should not be
dried in the tumble dryer.
Fabric softeners, or similar products, should only be
•
used as specified by the product manufacturer's
instructions.
Remove all objects from items that could be a source
•
of fire ignition such as lighters or matches.
Never stop a tumble dryer before the end of the drying
•
cycle unless all items are quickly removed and spread
out so that the heat is dissipated.
The final part of a tumble dryer cycle occurs without
•
heat (cool down cycle) to ensure that the items are left
at a temperature that ensures that the items will not be
damaged.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the
socket.

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging and the
transit bolts.
• Do not install or use a damaged
appliance.
• Follow the installation instruction
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use the appliance
where the temperature can be less
than 5°C or higher than 35°C.
• The floor area where the appliance is
to be installed must be flat, stable,
heat resistant and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• Always keep the appliance vertical
when being moved.
• The rear surface of the appliance
must be put against the wall.
• When the appliance is in its
permanent position, check that it is
fully level with the aid of a spirit level.
If it is not, adjust the feet accordingly.

2.2 Electrical connection

WARNING!
Risk of fire and electrical
shock.
• The appliance must be earthed.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
ENGLISH 23