Advice And Precautions; What To Do If - Rowenta POWERLINE Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
5 • Clean your vacuum cleaner
Wipe the body of the appliance and the accessories with a soft damp cloth and then dry.

ADVICE AND PRECAUTIONS

• Before every cycle of use, the cord must be fully unwound.
• Do not enter corners and do not pass over sharp shards.
• Do not move the vacuum cleaner by pulling the cord, but use the carrying handle.
• Do not lift the appliance by the cord.
• If you are using an extension cable, ensure that it is in perfect condition and matches the power of your
vacuum cleaner.
• Do not unplug the appliance by pulling the cord.
• Stop and disconnect your vacuum cleaner after each utilisation cycle.
• Only use dry accessories and original Rowenta bags.
• Verify that all filters are in place.
• Never use without bag and filter.
• In case of difficulty in obtaining bags and filters for the vacuum cleaner, contact Rowenta Consumer
Service on 0845 302 1454

WHAT TO DO IF...

IMPORTANT
When your vacuum cleaner is not working as it should be and before any verification, stop it by using the
stop/start pushbutton and unplug.
Your vacuum cleaner
will not start or does
not suck.
Your vacuum cleaner
has less suction
power, makes a
noise, and whistles.
The bag fill indicator
remains on red.
If a problem persists, take your vacuum cleaner to the nearest approved Rowenta Service Centre. See the
list of approved Rowenta Service Centres or contact Rowenta Customer Service: 0845 302 1454
* Depending on model
• The appliance is not receiving current: Check that it is correctly connected.
• An accessory or the tube is blocked: Unblock the accessory or the pipe.
• The cover is badly closed or cannot be closed: Check the position/or the
presence of the bag and re-close the cover.
• An accessory or the tube is partially blocked: Unblock the accessory or
the tube.
• The bag is full or saturated with fine dust: Replace the bag.
• The micro filter* or the HEPA filter* is saturated: Change the micro filter
or clean the HEPA filter if 6 months of use have elapsed, otherwise chan-
ge it following instructions in the notice.
• The power control is in minimum position: Increase the power using the
power control (except when cleaning fine fabrics).
• The suction fitting is difficult to move: Reduce the power using the power
control.
• The bag is full: Replace the bag.
12
EN
(fig. 20)

Publicité

Table des Matières
loading

Table des Matières