Standard Accessories; Applications; Battery Removal/Installation - Hitachi P 20DA Mode D'emploi

SPECIFICATIONS
POWER TOOL
Model
No-load speed
Cutting Width
Max. Cutting Depth
Rechargeable battery
Weight (with battery)
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

P20DA(BFK)
1. Box Wrench (for securing cutter blade) ........ 1
2. Set Gauge (for adjusting cutter height) ........ 1
3. Battery (EB12B) (attached to body) ................ 1
4. Charger (UC14YF or UC14YF2) ........................ 1
5. Plastic case .......................................................... 1
P20DA(NN)
1. Box Wrench (for securing cutter blade) ........ 1
2. Set Gauge (for adjusting cutter height) ........ 1
Standard accessories are subject to change without no-
tice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EB12S, EB12B)
2. Guide (with set screw)
3. Carbide Blade
4. Resharpenable Blade
5. Blade Sharpening Ass'y
Optional accessories are subject to change without no-
tice.

APPLICATIONS

Planing various wooden planks and panels.
(See Figs. 1-4)

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Fig. 5).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 5).
EB12B (2.0 Ah)
UC14YF / UC14YF2
7.2 – 14.4V
1.3 kg
P20DA
13000/min.
82 mm
0.5 mm
Ni-Cd battery, 12V
2.9 kg
CHARGING
Before using the planer, charge the battery as follows.
1. Connect the charger's power cord to an AC outlet.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Fig. 6.)
CAUTION
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as a deformed recharging termi-
nal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light con-
tinuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
English
6