General Cleaning; Clean The Air Filter - Grizzly BLS 30 Traduction De La Notice D'utilisation Originale

GB
Before every use, check the leaf blower
for obvious deficiencies, such as loose,
worn or damaged parts and for correct
seating of the parts. Replace damaged
parts. Check the bag regularly for wear
and tear.
Carry out the following maintenance and
cleaning work regularly. By this means, a
long and reliable life is guaranteed.

General cleaning

Clean the device in each case
immediately after working, since
otherwise mud with leaf residues
hardens and sets and can pos-
sibly no longer be removed without
dismantling the motor casing.
Such cleaning work is not cov-
ered by the guarantee.
Do not employ any cleaning agents
or solvents. They can irreparably
damage the device. Chemical sub-
stances can attack the plastic parts
of the device.
• Clean the device casing, the tube and
the ventilation slots regularly with a
soft brush or a cloth. Never clean the
device under running water.
• Take off the collection bag after finish-
ing work, turn it inside out and brush it
thoroughly. In this way, you avoid the
generation of mold and unpleasant
odours.
• Free the outlet area from possible
shredded residues.
90

Clean the Air Filter

Never operate the equipment
without an air filter, otherwise dust
and dirt will get into the motor and
result in damage to the machine.
Keep the air filter clean.
D
1. Switch off the equipment.
2. Loosen screw (15) on the air filter
cover and remove the cover (14).
3. Take the air filter (13) out of the filter
housing.
4. Clean the air filter (13) with soap and
water.
Never use petrol!
5. Allow the filter to dry in the air.
6. Reinsert the filter in reverse order.
Replace the air filter if it is worn,
damaged or heavily soiled.
Change the Spark Plug
Worn spark plugs or a spark gap
that is too large will result in a re-
duction of motor power.
E
1. Switch off the equipment.
2. Remove the cover (17) on the handle.
To do this prise the insert out of the
housing at the upper indentation (16).
3. Use both thumbs to push the cover
(17) upwards in the direction of the ar-
row.
4. Disconnect the spark plug terminal
from the spark plug.
5. Unscrew the spark plug anticlockwise
using a spark plug socket.
6. Insert the new spark plug.
7. Re-attach the spark plug terminal.
8. When inserting the cover, first insert
the two strips then press firmly.