Connecting Pw Amp To Speakers - Paradigm PREMIUM WIRELESS Série Mode D'emploi

CONNECTING PW AMP TO SPEAKERS

WARNING: Use Class 2 wiring only.
CAUTION: Do not connect speakers, which are rated
less than 4 Ohms to the Paradigm PW AMP.
CAUTION: While making connections with bare
wire, ensure that none of your bare wire comes in
contact with a an adjacent terminal.
The speakers to be connected to the Paradigm PW AMP should
be rated to handle at least 75 W for 8 Ohm speakers and at least
150 W for 4 Ohm speakers.
Your PW AMP's binding posts can be used with banana, plug
connectors, and bare wire.
12
IMPORTANT! Correct polarity (or phase) is critical for proper
soundstage imaging and bass performance. Connect one
speaker at a time to ensure proper connection of every channel.
The red (+) amplifier terminal must be connected to the red (+)
speaker terminal. The same applies to the black (–) terminals.
Make sure all wires are firmly fastened. Repeat this connection
procedure for each speaker in your system.
IMPORTANT! If you hear a distinct lack of bass and a dislocated
stereo image then one or more of your speakers may be connected
out of phase (polarity is reversed). Re-check to ensure that each
speaker's cable is connected with correct polarity: red (+) to red (+)
and black (–) to black (–).
Bare Wire Connectors:
If you are using speaker wire without banana plugs, simply press in the
spring loaded binding post to expose the connection hole. Insert the stripped
end of the speaker wire into the hole, then release the binding post. The
exposed speaker wire should be securely gripped by the binding post.
Banana Plug Connectors:
If you are using banana plugs, remove the end caps from the
PW AMP's binding posts to expose the banana plug socket;
insert the banana plug into the socket.