Quick Faucet Adaptor Connection - Haier HDC1804TW Mode D'emploi

English
qUICk FAUCET ADAPTER CONNECTION
The Quick Faucet Adapter easily connects to the sink faucet
A. First remove aerator from your faucet nozzle
and attach the quick connect threaded adapter
to the faucet. The quick connect faucet adapter
allows easy snap-on/snap-off connection to
standard (7/8" diameter) faucets.
B. Connect the dishwasher Quick Connect
Faucet Adapter to the faucet first to ensure the hose length fits
the dishwasher's selected location. Both hose end fittings must be
connected to the back of the dishwasher. The water intake and drain
plastic fittings are each a unique design and made to easily fit the
dishwasher to insure there is no mistake.
C. Water Intake Hose: Connect to the rear of the dishwasher using the
large, 4-corner shaped wing nut.
D. Drain Hose: Connect to the rear of the
dishwasher. It is suggested you use pliers to
tighten but DO NOT over tighten.
E. With both hoses connected, make sure you
can plug the power cord into a 120 volt,
grounded AC outlet, then turn the dishwasher
so it is facing forward.
F. Red Pressure Release Button: This red
button, located on the Quick Release Faucet Adapter, is used to
release the water line pressure. When you first connect to the water
faucet, you can press the red button to check the water is at the
desired temperature or to use the faucet normally without removing the
whole Quick Release Faucet Adapter.
Red Pressure
Release Button
G. With all the fittings connected, open the tap to test to make sure there
are no leaks. Connect the A/C power cord and use the dishwasher as
outlined in the manual.
8
Water Hose
Drain Hose
Faucet Water Connection
Drain
Water Intake Hose