Installation - Becker VarioControl VC320 Notice De Montage Et D'utilisation

Caution
Risk of injury by electric shock!
All electrical installations must be performed by an authorised electri-
cian!
When installing the roller shutter, always ensure that there is no risk of
the wiring being damaged when the system is in operation. Any sharp
edges which the cable comes into contact with must be covered with
suitable protective band. Damaged wiring may be replaced by the man-
ufacturer only.
If the VC320 is used to operate more than one drive, the drives must be
decoupled by relay controls. This does not apply to Becker drives with
electronic limit switches.
The switched current of the device must be observed at all times.

Installation

de
en
fr
nl
21