Mains Connection; On / Off Switch; Dust/Chip Exhaustion; Adjusting The Saw - ATIKA T 250 N-3 Notice Originale

Mains connection

Compare the voltage given on the machine model plate e.g.
220 – 240 V with the mains voltage and connect the saw to the
relevant and properly earthed plug.
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
 1.5 mm2 for cable lengths up to 25m
 2.5 mm2 for cable lengths over 25m

Alternating current motor:
Use a shockproof plug, mains voltage 220 – 240 V with residual
current circuit breaker (FI switch 30 mA).

Main fuse: 10 A inert

Power system impedance
In case of disadvantageous power system conditions short-term
voltage reductions can occur during the event of switching on of
the device which can influence other devices (e.g. jittering of a
lamp).
Such influences are not expected at a system impedance of
Z 0,346 Ω.
max

On / Off Switch

Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Switch on
Press the green button ( I ) on the switch.
 If there is a power cut, the machine switches off
automatically. To switch on again, press the green ( I )
button.
Switch off
Press the red button ( O ) on the switch.
Motor protection
 The motor is equipped with a safety switch and
switches off independently when overloaded.
It can be switched back on following cooling phase (5 -
10 min.).
First press
1. small button (17)
2. the green button ( I ) to start

Dust/chip exhaustion

The wood dust generated during operation impedes
the necessary view and is harmful to health to some
degree.
Unless the machine is used outdoors, it must be connected to a
chip exhaust system (e.g. portable dust remover).
Chip exhaustion
Connect a chip exhaust system or small vacuum cleaner
with suitable adapter to the chip exhaust neck (18) (Ø 40 mm).

Air velocity at the exhaust neck of the saw ≥ 20 m/sec.
Use a special exhaust device when exhausting dusts that are
harmful to health, carcinogen or dry.

Adjusting the saw

Pull the mains plug before performing
settings.

Adjusting the riving knife

The riving knife is an important safety device as it
prevents the workpiece from recoiling.
Always use the supplied riving knife.

To ensure the function of the riving knife its clearance to
the saw blade teeth must be correctly adjusted.
Adjusting the riving knife
For information on how to adjust the riving knife see the chapter
"Maintenance  Changing the saw blade".

Set the cutting height

The cut height can be adjusted stepless from 0 - 85

mm using the crank (6).
Before adjusting the cutting height, tighten the locking

screw for incline adjustment (15).
Set the cutting height 5 mm higher than the material

thickness.

Adjust saw blade pitch

The saw blade must not be set to the inclined
position when the blade is turning. The motor must
be switched off first.
Adjusting between 0° - 45°
1. Loosen the clamping screw (15).
2. Turn the handwheel until the required angle is shown (0° -
45°).
3. Retighten the clamping screw (15).
15