Samsung NV51K6650D Série Manuel D'utilisation page 38

Maintaining your appliance
How to run a Hybrid cleaning cycle
Remove all accessories from the oven.
1.
2. Open the oven door, and then touch Reservoir
reservoir. Grasp the front of the reservoir and pull it all the way out of the
slot.
3. Pour approximately 20 oz (600ml) of water into the water reservoir. Use
normal water only, not distilled water.
NOTE
You can open the reservoir by removing the rubber cap or by removing the clear
plastic top.
4. Replace the rubber cap or clear plastic top.
Return the reservoir to the slot, and then push it in. There will be slight click
5.
when it is in place correctly. Touch Reservoir
reservoir.
6. Close the oven door.
7. Touch Hybrid Clean.
8. Touch START/SET. The motor-driven door lock will engage automatically.
When the operation is complete, the display will blink and a beep will sound.
NOTE
Both oven doors are locked during Hybrid cleaning.
9. Touch OVEN OFF.
10. Clean the oven's interior. There will be a significant amount of water
remaining on the bottom of the oven after a Hybrid cleaning cycle. Remove
the residual water with a sponge or soft dry cloth.
NOTE
For Hybrid Cleaning, use exactly 20 oz (600ml). of water since this produces the
best results.
38 English
NV51K6650DS_DG68-00854A-00_EN+MES+CFR.indb 38
After a Hybrid cleaning cycle
•
. The oven ejects the water
•
•
•
•
. The oven retracts the water
•
•
•
•
•
•
Take care when opening the door after a Hybrid cleaning procedure has
ended. The water on the bottom is hot.
Open the oven door and remove the remaining water with a sponge. Do not
leave the residual water in the oven for any length of time. Wipe the oven
clean and dry with a soft cloth. Do not forget to wipe under the oven door
seal.
Use a detergent-soaked sponge, a soft brush, or a nylon scrubber to wipe the
oven interior. Remove stubborn residue with a nylon scourer. You can remove
lime deposits with a cloth soaked in vinegar.
If the oven remains dirty, you can repeat the procedure once the oven has
cooled.
For heavy residue, such as grease left over from roasting, we recommend
that you rub detergent into the residue before activating the Hybrid cleaning
function.
After cleaning, leave the oven door ajar at a 15° angle to allow the interior
enamel surface to dry thoroughly.
NOTE
You will not be able to start a Hybrid cleaning cycle if the control lockout
feature is activated or if the oven's temperature is too hot.
The oven doors lock automatically. The display will show the cleaning time
remaining. You cannot to open the oven doors until the temperature drops to
a safe/cool temperature.
The Hybrid clean feature can be used in only one oven at a time. While one
oven is in Hybrid cleaning mode, you cannot use the other oven for cooking.
If the oven is not clean after one cycle, repeat the cycle.
You cannot set the oven for cooking until the oven is cool enough for the door
to unlock.
2016-08-16 6:52:24