Control Panel Display Modes; Setting The Clock; Setting The Kitchen Timer - Samsung NV51K6650D Série Manuel D'utilisation

Operating the oven

Control panel display modes

Sleep Mode
Your control panel will remain in a sleep mode when not in use. Only the clock will
display. You will need to wake the control panel to begin any function.
Wake Mode
To wake the control panel, touch Touch to Wake-Up/Sleep. After 2 minutes without
activity (or one minute when the oven is operating in standby mode), the control
panel will return to Sleep mode.
Select upper or lower oven
To change between the upper and lower oven, touch the UPPER OVEN or LOWER
OVEN area.
The control panel will be activated after you select an oven.
20 English
NV51K6650DS_DG68-00854A-00_EN+MES+CFR.indb 20

Setting the clock

The clock must be set to the correct time of day for the automatic oven timing
functions to work properly.
• The time of day cannot be changed during timed cooking, delay-timed
cooking, or a self-cleaning cycle.
• You can choose between a 12-hour or 24-hour display. The default is 12-hour.
How to set the clock
1. Touch Clock.
2. Touch Clock to select AM or PM. (Skip this step if you are setting the clock to
24 hour display mode.)
3. Touch keys in the number pad to set the current time of day.
4. Touch Clock or START/SET to save the changes.

Setting the kitchen timer

The kitchen timer serves as an extra timer that will beep when the set time has
elapsed. It does not start or stop cooking functions. You can use the kitchen timer
with any of the other oven functions.
How to set the timer
1. Touch Timer On/Off.
2. Touch number keys in the number pad to set the hours and minutes. The timer
can be set for any amount of time from 1 minute to 9 hours and 59 minutes. If
you make a mistake, touch Clear, and then enter the amount of time again.
3. Touch Timer On/Off or START/SET.
4. When the set time has elapsed, the oven will beep and the display will show
End until you touch Timer On/Off. You can cancel the timer at any time by
touching Timer On/Off.
2016-08-16 6:52:20