Tiiwee Home Alarm Kit Manuel page 8

 Press the On/Off Button [ ] to exit the pairing mode OR pair another sensor for the
next zone:
Setup Zones 2-4
 Now short press the SET button [
upper light is now lit.
 Activate the respective units (door sensor or PIR) which correspond to Zone 2. Two
beeps will be heard. The sensor for Zone 2 is now properly connected. Other sensors
can be connected for this zone by activating it at this stage.
 Short press the SET button [
add further sensors
 Press the On/Off Button [ ] to exit the pairing mode.
Pairing with additional remote control
Your remote control is ready for use and already paired with your Alarm unit but you can
add more remote controls if desired.
IMPORTANT: Connection mode for remote controls is activated by once long pressing the
SET button. All 4 LEDs will now be lit.
IMPORTANT: If just one LED is lit at this stage, you probably have pressed the SET button
again after Long pressing the SET button. This means that the A1 is in the pairing mode for
sensors and the remote control will be paired incorrectly. If this is the case, exit the
pairing-mode by pressing the On/Off button shortly. Now, long press the SET button once
to enter pairing-mode for remote controls.
The image below shows the correct stage when remote controls can be paired:
] again to select the next zone. The second
] to select Zone 3 or Zone 4 and do as described to
All 4 LEDs are lit and the A1
alarm unit is now ready for
pairing remote controls.
8