Tiiwee Home Alarm Kit Manuel page 7

Pairing with additional sensors
IMPORTANT: In the procedure below, you will need to activate sensors to pair them with
the Alarm unit. A door sensor can be activated by keeping the sensor and magnet against
each other and then move them away from each other. A PIR sensor can be activated by
waving your hand in front of it.
IMPORTANT: Do not pair sensors when all 4 LEDs are lit. When you want to pair a sensor
and you have entered pairing mode by long pressing the SET button and all 4 LEDs are lit,
you should short press the SET button again to select one of the 4 zones. For instance, if
you want to pair a sensor to zone 3, short press the SET button another three times after
you entered pairing mode.
The image below shows an example for zone 2.
Entering pairing mode
 Make sure the Alarm unit is On. If this is not the case, long press the On/Off Button
[ ].
 Long press the SET button [
lights on the front will light up.
Setup Zone 1
 Now short press the SET button [
is now lit.
 Activate the respective unit (door sensor or PIR) which corresponds to Zone 1. Two
beeps will be heard. The sensor for Zone 1 is now properly connected. Other sensors
can be connected for this zone by activating it at this stage.
This A1 Alarm is ready
for pairing sensors in
zone 2
] on the Alarm unit to enter pairing mode. The four
] once to select Zone 1. The first upper light
7