Tiiwee Home Alarm Kit Manuel page 13

How to reset the A1 Alarm unit:
Deleting the remote controls:
 Put the A1 alarm unit into pairing mode by long pressing the Set button (all 4 LEDs
are lit) - do NOT select a zone yet!
 Long press the Set button again for about 5 seconds - 5 beeps are heard
 Now, all remote controls have been removed from the unit
Deleting the sensors from all zones:
 Please put the A1 alarm unit into pairing mode by long pressing the Set button (all 4
LEDs are lit)
 Now you MUST select zone 1 by short pressing the Set button again
 The first LED on the top is now lit
 Long press the Set button again for about 5 seconds - 5 beeps are heard
 Now all sensors have been removed from zone 1
 IMPORTANT: Please proceed in the same way for all remaining zones (zone 2 - 4)
 Now, all sensors have been removed from the system
You can now pair all sensors and remote controls again.
13