Oregon 596281 Manuel D'utilisation page 12

STEP 5:
Confirm stand is in deployed position. Carefully lower the beam assembly (4) onto the tongue assembly (1). Lock the
beam into position using lock pin (17). Attach manual canister (18) to tongue assembly (1) using two self-tapping
screws (19).
STEP 6:
Connect the end of the 1/2 ID x 38" hydraulic pressure hose (20) coming from the fitting on the pump to the fitting on
the valve. Refer to illustration below.
STEP 7:
Slide one worm gear clamp (21) on the end of the 3/4 x 56" hydraulic return hose (22) that comes from the fitting on the
filter. Then connect the hose to the fitting on the valve. Tighten worm gear clamp. Refer to illustration below.
ITEM DESCRIPTION
20
Pressure Hose
21
Worm Gear Clamp
22
3/4" Return Hose
Page 12
ITEM DESCRIPTION
1
Tongue Assembly
4
Beam Assembly
17
5/16 x 3-1/4 Square Lock Pin
18
Manual Canister
19
1/4 x 3/4 Self-Tapping Screw
QTY
1
1
1
QTY
1
1
1
1
2