Using The Mains Adapter - DS Produkte WSC802 Mode D'emploi

Sensor
1. The battery compartment cover is located on the bottom
of the sensor. Press together the two battery compart-
ment clips and lift off the cover.
2. Insert the batteries into the battery compartment as
indicated. Pay attention to the correct polarity (+/–)!
3. Put the battery compartment cover into place again. The
two locking lugs in the battery compartment must be
heard to engage in the two clips of the cover.
Basic Device
2. Insert the batteries into the battery compartment as indi-
cated. Pay attention to the correct polarity (+/–)!
3. Fit the battery compartment cover again and press it shut
until it is heard to engage.
An indicator at the bottom left of the display tells you
when the batteries start to weaken.

Using the Mains Adapter

You require a DC 7 V mains adapter with a
connector (Ø: 3.5 mm / 1.35 mm).
4_DE-GB-FR-NL_A6_V0.indb 34 4_DE-GB-FR-NL_A6_V0.indb 34
1. There is a large battery
compartment on the bottom
of the basic device. Reach
into the recess above the
battery compartment cover,
press the locking catch down
slightly and remove the cover.
barrel
34
11.10.2013 10:20:41 11.10.2013 10:20:41