Installing Magicspeed; Tools Required - Dometic MSBE 7 Instructions De Montage Et De Service

MagicSpeed MSBE7
6

Installing MagicSpeed

6.1

Tools required

For installation and assembly you will need the following tools:
• Drill bit set (fig. 1 1, page 3)
• Electric drill (fig. 1 2, page 3)
• Screwdriver (fig. 1 3, page 3)
• Set of ring or open-ended spanners (fig. 1 4, page 3)
• Set of box spanners (fig. 1 5, page 3)
• Measuring ruler (fig. 1 6, page 3)
• Hammer (fig. 1 7, page 3)
• Centre punch (fig. 1 8, page 3)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 1 9, page 3) or voltmeter (fig. 1 10, page 3)
• Insulating tape (fig. 1 12, page 3)
• Sealant
• Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and cable binders.
6.2 Installing the control lever
When selecting the installation location, observe the following instructions:
• Make sure the driver does not have to reach through the steering wheel to use the control lever.
• Install the control lever in a suitable position on the steering column where it can be safely used
at all times.
A
NOTICE!
Before drilling holes, make sure the drill bit will not damage anything on the other side
(fig. 2, page 3).
➤ Remove the cover on the steering column.
➤ Drill a 10 mm hole.
➤ Insert the outer adaptor (fig. 6 2, page 5) onto the thread of the control lever (fig. 6 1,
page 5).
➤ Guide the thread through the drill hole.
➤ Attach the control lever by pushing the spring washers (fig. 6 4, page 5) and the inner adap-
tor (fig. 6 3, page 5) onto the thread and tightening with the nut (fig. 6 5, page 5).
EN
Installing MagicSpeed
11