Accessories - Technibel CWX Série Notice D'installation

5 - FRAME / GRILLE INSTALLATION
• The frame / grille comes in a separate box.
- Code K60N129T for CWX3 and 5
- Code K60N130T for CWX6
- Code K60N131T for CWX8 and 10
• Before installing the facade:
- Remove the retaining screws (1) from the locks (2) on each side
(remember to replace these screws after installation).
- To open the grille (3), turn the two locks (2) in the direction of the
arrow.
- Open the grille (3) 45°.
- Detach the safety cord (4) from the frame (remember to replace it
again after installation).
- Pull the grille inward to remove it from the frame.
• To install the facade:
- Turn the two locking clips (5) downward.
- Attach the frame of the facade (6) to the unit with the two hooks (7)
by lining them up with the locking clips (5).
Note (for CWX 6-8-10 models)
- Observe the position of the facade frame as the hooks are not
the same size. Correctly present them in front of the
corresponding locking clips.
- Check the correct position of the facade frame in relation to
the false ceiling. Adjust the position of the internal unit, as
required.
- Secure the facade frame to the unit using the special screws and
washers (8) provided.
- Fit the grille (3) making sure that the filter (9) is correctly installed.
- Hook the grille safety cord to the frame, close the grille and replace
the lock retaining screws.

6 - ACCESSORIES

VALVE KIT - CODE 70600088 - CWX 3-5
• The valve kit includes:
- the valve body,
- 2 swivel couplings,
- actuator (with 230V "On/Off" heating element).
• Assembly
A -Valve directly
connections
• Screw the "2 part" portion of the swivel coupling
on the female coupling of the unit. Use a stepped
spanner or a hex wrench. Put sealing compound
or Teflon tape on the threads.
Important: Hold the unit's couplings with a
wrench while tightening to avoid twisting the
tubes inside the unit.
• Screw the "1 part" portion of the swivel coupling
onto the valve threads.
Use sealing compound or Teflon on the threads.
on the unit's hydraulic
4
5
6
8
Female couplings
of the unit
Swivel coupling
("2 parts" portion)
Swivel coupling
("1 part" portion)
Valve
3
1 2
GB
5
7
9
3
11