System Setup - Phonocar VM 299 Notice De Montage Et D'emploi

The VM299 is entirely governed through Remote-Control.
SET UP
Image setting
REC. Setting
REC. Mode
Playback
System Setting
EXIT
Select Enter Esc: To Last Page Menu: To Main Menu
IMAGE SETTING
depend from the Quality-level chosen for the following parameters:
Image setting
Quality Frame Rate
30 fps
H
15 fps
M
5 fps
L
REC SETTING
Start Recording at your own choice:
REC. Setting
Scheduled T.
Overwrite Motion Det.
Yes Mask Area
No Sensivity
Speed
Noise Magin
You can choose various recording-qualities and picture shooting-speeds. The files-dimensions
Resolution
D1
VGA
QVGA
Section
15 min
30 min
1 hr

SYSTEM SETUP

SET UP System-Setup
Press MENU to enter Main Menu. Select requested function from the
given list and press OK to confirm.
• QUALITY select Definition-level of picture
H (Max. Definition), M (Medium Definition), L (Low Definition). Move with
the help of arrow-keys. Confirm pressing OK.
• FRAME RATE select number of Photograms per Second (fps=frame
per second).
30fps Real-Time Recording (fluid).
15fps o 5fps, Recorded Pictures will appear Step by Step.
• RESOLUTION Select Picture-Resolution.
The higher the Resolution, the better the Reproduction-Quality:
D1 Resolution 704x576 pixel
VGA Resolution 640x576 pixel
QVGA Resolution 320x288 pixel
Recording-Time at Table page 14.
•SCHEDULED TIME Select Recording Duration, Date and Time:
2013/09/10 7:30
The example stands for Registration starting on Sept. 10th 2013, at 7:30,
ending on Sept. 12 2013, at 18.00 hours.
th
• OVERWRITE You can superpose the elder Recordings, when space on
SD-card is full.
YES Superpose the old Files with new ones.
NO Interrupt recording-process when space on SD-card is fully exhau-
sted.
• SECTION The recordins will automatically be divided into various Files
lasting 15 minutes, 30 minutes or 1 hour.
• MOTION DETECTION Start recording-process when movement is
detected.
MASK AREA The picture will receive a grill of 192 cubes where you can cover
those areas where movements need not be detected. Move, with the help
of the arrow-keys, within the grill and press OK on each of the cubes where
movements should not be detected.
The selected cubes will turn BLUE, confirming that those areas are covered.
SENSIVITY Detection-Sensitivity: H – High / M – Medium / L – Low
SPEED Detection-Speed: H – High / M – Medium / L – Low
Note: A very slow movement will NOT be detected, when Detection-Sensitiv-
ity is set on H (High).
NOISE MARGIN Picture problems. This Parameter is not available.
6
2013/09/12 18:00
GB